SNAPTOGGLE heavy-duty toggle bolts carry twice the load in a smaller hole than standard wing anchors. A patented strap design with sturdier straps and smaller ratchet interval adjusts more precisely and snaps off flush to the surface.
SNAPTOGGLE heavy-duty toggle bolts do NOT spin when installed with a screw gun and provide superior holding with metal-to-metal fastening.
Materials / Finishes
- Channel: Yellow zinc-plated cold rolled steel or 304 stainless steel
- Metal Channel is RoHS-Compliant
- Straps and handle: High impact polystyrene
- Cap/Hat: Translucent polypropylene co-polymer
Features and Benefits
- Strong – up to 2x the load of an old-fashioned wing toggle
- Solid metal channel resists vibration and shock
- bolt is centered in channel and positioned for precise installation
- bolt threads never touch interior surface of hole and so can’t saw through substrate
- Save time – at least 6 minutes per anchor versus wing toggles
- Can use a screw gun – anchor does not spin
- Save money – turn a 2-person job into a 1-person job
- Use a shorter bolt – no need to carry a wing through the wall
- Patented strap design with sturdier straps and smaller
ratchet interval:
- adjusts more precisely and snaps off flush to wall,
ceiling, or floor
- does not break prematurely
- pushes aside insulation
- Smallest installation hole for each bolt size:
- maintains integrity of wall, ceiling, or floor, strengthening
the anchoring
- ends the need to patch an oversized hole [a 1/4" wing toggle requires a 3/4" diameter hole: 50% larger than the 1/2" diameter hole used by the 1/4” SNAPTOGGLE anchor]
Installation
- Drill appropriate size hole. Hold metal channel flat alongside plastic straps & slide channel through the hole. Minimum clearance behind wall: only 1-7/8”
- Hold ends of straps together between thumb & forefinger and pull toward you until channel rests behind wall. Ratchet cap along straps with other hand until flange of cap is flush with wall.
- Place thumb between straps at wall. Push thumb side to side, snapping off straps level with flange of cap.
- Place item over flange. Insert bolt and tighten until snug against item, then stop. Use machine screw or bolt to match thread in metal channel.
